NEC Express5800/GT110b User's Guide download pdf (Page 273)

Troubleshooting 8-27

Problems with NEC EXPRESSBUILDER

When the server is not booted from the NEC EXPRESSBUILDER DVD, check the following:

 Did you set the NEC EXPRESSBUILDER during POST and restart the server?

→ If you do not set the NEC EXPRESSBUILDER during POST and restart the

server, an error message will appear or the OS will boot.

 Is BIOS configuration correct?

→ The boot device order may be specified with the BIOS SETUP utility of the server.

Use the BIOS Setup utility to change the boot device order to boot the system

from the optical disk drive first.

 Did you connect an unformatted Flash FDD or insert an unformatted floppy disk?

→ Please connect a formatted Flash FDD or insert a formatted floppy disk.

 If [Os installation ***default***] is selected at Boot selection screen, following

message is displayed.

After this message appears, check the error and take the appropriate corrective action

according to the message listed in the table below.

Message Cause

This EXPRESSBUILDER version was not

designed for this computer.

Insert the correct version and click [OK].

(When you click [OK], the computer reboots.)

This NEC EXPRESSBUILDER version is

not designed for this server.

Execute the NEC EXPRESSBUILDER on

the compliant server.

EXPRESSBUILDER could not get the

hardware parameters written in this

motherboard.

This version is not designed for this computer

or the motherboard may be broken. (When

you click [OK], the computer reboots.)

The hardware parameters written in this

motherboard are incorrect.

This version is not designed for this computer

or the motherboard may be broken.

This message is shown when NEC

EXPRESSBUILDER could not find

system-specific information because of

mother board exchange and so on.

 If the creation of the OEM-Disk for Windows failed, the following message will be

displayed.

Confirm the message, and then try the solution described in the "Cause".

Error message Cause

The format went wrong. It is write-protected

or the floppy disk may be damaged. Please

check a floppy disk and perform creation of

OEM-Disk again.

Failed in the deletion of the file. Please

confirm whether the media is not

write-protected state or not.

The Flush FDD or the floppy disk is

write-protected.

Cancel write-protected state.

If you have already canceled

write-protected state, connect the USB

floppy disk drive again.

1 2 ... 268 269 270 271 272 273 274 275 276 277 278 ... 493 494

Comments to this Manuals

No comments

NEC Express5800/GT110b User's Guide Page 273

Comments to this Manuals

Related products and manuals for Servers NEC Express5800/GT110b