Configuring Your Server 4-7
Keyboard
To set Numlock
Select [Advanced] - [Numlock] – [On]/[Off].
Security
To set passwords on the BIOS
Select [Security] - [Set Supervisor Password] and enter a password.
Select [Security] - [Set User Password] and enter a password.
Set Supervisor password first, then User password.
External Devices
To set up external devices
Select [Advanced] - [Peripheral Configuration] and set up each device.
Internal Devices
To install the RAID Controller card or SCSI controller card
Select [Advanced] - [PCI Configuration] - [PCI Slot n Option ROM] - [Enabled].
n: slot number
To clear the hardware configuration data (after installing/removing internal devices)
Select [Advanced] - [Reset Configuration Data] - [Yes] and reboot.
Running the Server with the Fan Low-speed (Silent) Mode)
To run the server with the fan set to low-speed (silent) mode
Select [Server] - [Fan Control Mode] - [Low].
If a board is inserted in the server’s PCI slot, the fan cannot be set to low-speed (silent)
mode.
Saving the Configuration Data
To save the current configuration data and exit from SETUP
Select [Exit] - [Exit Saving Changes].
To discard changes to the current configuration data and exit from SETUP
Select [Exit] - [Exit Discarding Changes].
To load the default setup
Select [Exit] - [Load Setup Defaults].
To discard changes to the current configuration data
Select [Exit] - [Discard Changes].
Comments to this Manuals