NEC Express5800/R110d-1E Installation Guide download pdf (Page 14)

3.3 Requirements for connection between the management PC a

nd managed server

Provide an environment in accordance with the co nnection type to be used.

 LAN connection

- TCP/IP network

• Do not use a cross cable to connect the manager server and managed server.

• If you use the managed server integrated BMC, LAN port that BMC uses depends on the type of

BMC. Some BMC uses standard LAN port. Other BMC uses a Management LAN Port. There are 2

types of managed servers on that BMC uses standard LAN port to connect with NEC ESMPRO

Manager: one type is permitted to use only LAN1 port, and the other type is permitted to use both

LAN1 and LAN2 ports. See "Appendix C Managed Servers Summary" in "NEC ESMPRO

Manager Ver.5 Setup Guide".

- Modem connection (It can be only used to connect with BMC)

- Phone line

- Modem

Use a modem that supports the following functions:

Baud rate : 19.2Kbps

Data bits : 8bit

Parity : None

Stop bits : 1bit

Flow control : Hardware (CTS/RTS)

• Use the modem recommended for NEC Express 5800 series on the managed server.

• Connect the modem to the serial port 2 on the managed server.

- Other Information

When BMC send alert to management PC via modem, it is necessary the following:

・ Dial-up router or PPP server

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 73 74

No comments

NEC Express5800/R110d-1E Installation Guide Page 14