Direct connection (It can be o nly used to connect with BMC)
- RS-232C cross cable
The serial port for direct connection on ESMPRO server. NEC ESMPRO Manager must be set following on
the operating system.
Bits per speed : It should be s et a sam e value with a v alue of BMC co nfiguration on a man
aged server. The default va lue of BMC configuration is 19.2Kbps.
Data bits : 8bit
arity : None
Stop bits : 1bit
Flow control : Hardware (CTS/RTS)
• Do not use an interlink cable.
• Connect the RS-232C cross cable to serial port 2 on the managed server.
• Some models of managed servers do not permit use of any RS-232C cross cable other than the
specified one. See the Maintenance Guide provided with the server.
15
Comments to this Manuals