Nec MT 1020G /820G User Manual download pdf (Page 26)

E – 26

Settings Menu Enables you to set preferences and other operating options. Use the “Select” button on the projector

cabinet or (▲) (▼) buttons on your remote control to access the submenu you want.

Custom Memory

This enables you to save your current settings for an RGB source in one of five memories, Custom

1-5.

“Custom 6” is read only. This feature is useful when an XGA image (10242768) is displayed with

a notebook computer supported by SXGA (128021024) and when an SVGA image (8002600) is

displayed with a notebook computer supported by XGA (10242768).

To change the STANDARD settings, proceed as follows:

1. Connect your computer to the MultSync MT1020G/820G.

2. Select the "STANDARD" in RGB 1 or RGB 2 source.

3. Adjust the horizontal/vertical position, Picture, and Fine picture adjustments.

4. Select the Custom Memory icon.

5. Press the "Adjust" (+) or (–) buttons to choose a memory location, then press "Enter" on the

cabinet or the "Left Click" on your remote control to save the new settings.

If you do not want to change the STANDARD settings, first select the Custom Memory icon,

then do the same as step5.

Image Loop

This feature enables you to “capture” an image from a source that is currently being displayed. Up

to 8 images can be stored.

Press the “Adjust” (+) or (–) buttons to select "Start" for the image you want to loop and “Capture”

for the image you want to capture or to select “Delete” and delete all captured images from memory.

Press “Enter” on the cabinet or the “Left Click” on your remote control to save your image loop

changes. To stop an image loop, press one of the “Video”, “S-Video”, “RGB1” or “RGB2” button,

or use the Source menu.

Background

Use this feature to display a black or blue screen or to start an image loop when no input signal is

available.

Press the “Adjust” (+) or (–) buttons to choose the back screen you want — blue, black or an image

loop. Press “Enter” on the cabinet or the “Left Click” on your remote control to save your change.

NOTE: This feature will not work with Video or S-video sources and the projector will display a black image

if no input signal is present.

Projection

This reorients your image for your type of projection. Press the “Adjust” (+) or (–) button until it is

correct. Press “ENTER” on the cabinet or the “Left Click” on your remote control to save your

change. The options are: front floor projection, rear ceiling projection, rear floor projection, and

front ceiling projection.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 37 38

No comments

Nec MT 1020G /820G User Manual Page 26