NEC Express5800/R110f-1E User Manual download pdf (Page 41)

Operation View

The Operation View indicates the status and results of operations executed in the server after the RAID Viewer is

started.

Figure 4 Op

eration View

The following operations may appear on the Operation View. For each operation, the target RAID Controller, Logical Drive,

or Physical Device, and the status of the operation appear.

Initialize

Rebuild

Consistency Check

Operations being executed while the RAID Viewer is started and those started after the RAID Viewer is started are listed.

You can see the status and result of operations by the value of [Status].

Status Description

Running (N %) The operation is running (N is progress).

Completed The operation completed.

Failed The operation failed.

Stopped The operation stopped (by [Stop]).

Paused (N %) The operation is paused (N is progress).

Queued (N %) The operation is queued (N is progress).

Stop Processing The operation is being stopped (by [Stop]).

Terminated operations continue to appear until the RAID Viewer is closed. However, the terminated operations will not

appear at the next start of the RAID Viewer.

o delete an operation terminated while the RAID Viewer is

started, click the operation to be deleted and [Delete].

An operation

being executed can be stopped on the way. To

do this, click the operation to be stopped and [Stop].

 Operations allowed to be stopped vary depending on RAID System Management Modes.

See "Standard and Advanced Modes" for details.

 The st

op of the operation might not be supported according to the kind of RAID Controller.

In that case, the [Stop] does not become effective.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 134 135

No comments

NEC Express5800/R110f-1E User Manual Page 41