NEC Express5800/R110f-1E User Manual download pdf (Page 93)

Executing Consistency Check for all Logical Drives for a RAID Controller which

not support Patrol Read or of which the Patrol Read is disabled.

Use "ccs" command of the raidcmd.

Stopping Consistency Check

You can stop Consistency Check being executed on the way. The procedure of stopping Consistency Check is

described below.

RAID Viewer

Step 1 Start the RAID Viewer. See [Operation View] while Consistency Check is executed.

Step 2

Click operation [Consistency Check]

which you want to stop. Click [Stop] on the Operation

View. After the Consistency Check is stopped,

[Status] on the Operation View is changed to

opped].

d raidcm

Step 1 Execute "cc" command with -op option

stency Check is stopped (If specify "all" as parameter, the targets are all Logical Drives

ped, the raidcmd terminates normally. The stopped Consistency Check

disappears from the list of "oplist" command.

Checking Result of Executing Consistency Check

nd the following parameters.

-c : Number of the RAID Controller containing the Logical

Drive for which Consistency Check is stopped (If specify

"all" as parameter, the targets are all Logical Drives of all

RAID Controllers)

-l : Number of the Logical Drive for which Consi

of RAID Controllers specified by -c)

> raidcmd cc -c=1 -l=2 -op=stop

raidcmd oplist >

RAI

Controller #1

-o

p : Specify "stop" to stop Consistency Check

Step 2 After the Consistency Check is stop

You can find the result of executing Consistency Check by checking the RAID Log of the Universal RAID Utilit

If a problem is detected, the Consistency Check logs both the message indicating the

result if Consistency

Check has been finished successfully and that indicating the error in the RAID Log .

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 134 135

No comments

NEC Express5800/R110f-1E User Manual Page 93