NEC Express5800/R110f-1E User Manual download pdf (Page 104)

raidcmd

104

Step 1

Execute the "optctrl" command with -dst

option and the defined parameters.

-c : Number of RAID Controller for which Device Standby

Time is set.

-dst : Select 0.5, 1, 2, 4, or 8 hours to change the Device

Standby Time.

Ex. Changes the value of Device Standby Time to

"2hours" (RAID Controller Number is 1).

raidcmd optctrl -c=1 -dst=2

Step 2 The property of the RAID Controller

changes after the setting has been changed

successfully.

[Device Standby Time]: Value after change

Use the “property” command to see the property of the RAID Controller.

-tq: Specify rc to see the property of the RAID Controller.

-c: The Number of the RAID Controller of which you are going to check the property.

Rebuild Priority : Middle

Consistency Check Priority : Middle

Patrol Read : Enable

Patrol Read Priority : High

Buzzer Setting : Disable

Power Saving(Hot Spare) : Enable

Device Standby Time : 2 hours

> raidcmd optctrl -c=1 -dst=2

> raidcmd property -tg=rc -c=1

RAID Controller #1

ID : 0

Vendor : LSI Corporation

Model : LSI MegaRAID SAS 9267-8i

Firmware Version : 3.140.05-1294

Cache Size : 1,024MB

Premium Feature : CacheCade

Battery Status : Normal

Ex. Referring to property of the RAID Controller (RAID Controller Number 1)

raidcmd property -tg=rc -c=1

Only a single parameter can be set at a time. If execute "optctrl" command with -psd option

and -dst option at the same time, command is failed.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 134 135

No comments

NEC Express5800/R110f-1E User Manual Page 104